- 1-844-200-5436
- My Orders
- Cart 0 item(s)
Refine Selection Here:
Item # 3319979
Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.
OEM Part - Manufacturer #W10721967
Item # 2670
Washing machine clutch assembly with hardware. *Blue spring for regular, large, extra and super capacity washers, black for compact models. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.
OEM Part - Manufacturer #285785
Item # 3346
Dryer belt tension idler pulley assembly.When the idler pulley goes bad it will usually make a high pitch squeeling or rattling noise.
OEM Part - Manufacturer #WP691366
Item # 671098
Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.
OEM Part - Manufacturer #WP63907
Item # 868761
Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.
OEM Part - Manufacturer #285805
Item # 1206293
Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.
OEM Part - Manufacturer #W10120998
Item # 1195942
Fabric softener dispenser, white, measures approximately 5" round x 4 1/4" tall
OEM Part - Manufacturer #8575076A
Item # 2584
Dryer drum drive motor. Includes pulley for dryer drum drive belt. Other shaft has reverse threads for blower wheel. Common symptoms of a bad drive motor are:
-Dryer stops turning during cycle
-Dryer won't start
-Dryer won't turn at all
-Dryer drive motor is loud
OEM Part - Manufacturer #279827
Item # 525385
Dryer moisture sensor bar. This moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your moisture sensor is defective, the dryer may shut off too early or continue running for a while after the clothes are dry. Two required.
OEM Part - Manufacturer #WP3387223
Item # 897710
Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.
OEM Part - Manufacturer #279973
Item # 1181075
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
OEM Part - Manufacturer #WP8577274
Item # 3415
Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.
OEM Part - Manufacturer #279311
Item # 185
White touch-up paint. .6 oz.
OEM Part - Manufacturer #72017
Item # 2958
Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.
OEM Part - Manufacturer #279640
Item # 1871380
Washer main drive belt. This belt is located under the washing machine and is used to drive the splutch pulley. It goes around the motor & splutch pulleys. Worn or broken drive belt can cause spin or washplate problems.
OEM Part - Manufacturer #WPW10006384
