Washer Dryer Combo Parts (502 results)

Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

OEM Part - Manufacturer #279640

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

Dryer tri-ring retainer for drum support rollers.

OEM Part - Manufacturer #WPW10512946

Whirlpool's transmission is a genuine replacement part for washing machines that ensures optimal turning motion for the drum, resulting in the best wash possible for clothes.

OEM Part - Manufacturer #3360629

The drive coupler can wear out significantly over time. Consider replacing the drive coupler while you have the washer apart.

Spring clip, knob

OEM Part - Manufacturer #WP688805

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

OEM Part - Manufacturer #279769

The fuse can be tested using a multimeter meter

The Whirlpool Agitator Bolt WP358237 is a high-quality replacement part for washers, with a 5/16 inch head, rubber washer, and thread sealant. It replaces several part numbers. Disconnect the appliance from all utilities prior to installation.

OEM Part - Manufacturer #WP358237

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

The Whirlpool Agitator Cam Repair Kit 285809 is a high-quality replacement for multiple part numbers. It contains several parts and is used to rotate the agitator. Disconnect the appliance from all utilities prior to installation.

OEM Part - Manufacturer #285809

If the bolt is stripped, it should be replaced.

This is a genuine replacement part. The model number and name for the following item is: Whirlpool 279457 Wire Kit.

OEM Part - Manufacturer #279457

Motor pulley, 60 hertz

OEM Part - Manufacturer #WP8066184

Drive belt

OEM Part - Manufacturer #W11239857

Washing machine drain pump. *Coin trap only available with pump assembly. If the washer does not drain the pump could be locked up or a small object may be clogging it. Also a small leak in front of the washer could be caused by a defective pump.

OEM Part - Manufacturer #WPW10730972

If your washer smells we recommend cleaning it with Affresh once a month.

White washer lid strike assembly. The strike is what the lid lock hooks onto to lock the washing machine lid. If old strike looks different the latch may need to be replaced as well.

OEM Part - Manufacturer #W10837741