Whirlpool Washer/Dryer Combo Model LTG6234DZ1 Parts

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834

Washer drive motor coupler. New style with metal sleeves for added strength. This version replaces all previous motor coupler styles and versions. For direct drive washing machines. Common symptom of failed coupler is washer will fill, not agitate or spin but will drain the water from the tub.

OEM Part - Manufacturer #285753A

Helpful tool is the suggested Multi-Bit Screwdriver

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #661570V

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Dryer door catch kit. This kit includes three different door catches; you will need to select the door catch that fits your model.

OEM Part - Manufacturer #279570

Washing machine agitator repair kit with a medium length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.

OEM Part - Manufacturer #285811

Consider replacing the bolt and getting a spare set of dog ears. The bolt can get corroded and the dog ears wear out over time.

Washing machine clutch assembly with hardware. *Blue spring for large capacity washers, black for compacts. A worn clutch often causes a slower spin speed which leaves the clothes soaked after the cycle.

OEM Part - Manufacturer #285785

Dryer igniter kit. This igniter will replace both round and flat style igniters. The kit includes the bracket, wire nuts and mounting screw. Be aware the igniter is very fragile and should be handled carefully.

OEM Part - Manufacturer #279311

Consider replacing the gas valve coils while you have the dryer apart.

Washing machine suspension spring. If the suspension spring is broken, the washer will be off balance.

OEM Part - Manufacturer #WP63907

Screw

OEM Part - Manufacturer #WP308685

Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.

OEM Part - Manufacturer #285805

Dryer tri-ring retainer for drum support rollers.

OEM Part - Manufacturer #WPW10512946

5-foot-long rubber fill hose for washing machines. Used for hot or cold water.

OEM Part - Manufacturer #WP89503

Over time, rubber hoses dry out and become susceptible to leaks or bursts. Replace fill hoses every 5 years to reduce the risk of hose failure.