Whirlpool Washer/Dryer Combo Model 7MWET4027HW0 Parts

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #349241T

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #661570V

Agitator Dogs - High-quality replacement part from Whirlpool. This kit can be used if the top part of the agitator is not moving properly but the bottom part is.

OEM Part - Manufacturer #80040

If your washer has an unpleasant odor than we recommend using Affresh washing machine cleaner.

Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.

OEM Part - Manufacturer #W10721967

The drive belt wears out over time. You may want to replace the drive belt while the washer is apart.

Mode shift actuator with 6 pin wire connection

OEM Part - Manufacturer #W10913953

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Door catch

OEM Part - Manufacturer #WPW10610880

Suspension rod kit

OEM Part - Manufacturer #W10780045

Washer main drive belt. This belt is located under the washing machine and is used to drive the splutch pulley. It goes around the motor & splutch pulleys. Worn or broken drive belt can cause spin or washplate problems.

OEM Part - Manufacturer #WPW10006384

White Touch Up Paint

OEM Part - Manufacturer #72017

Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

OEM Part - Manufacturer #279640

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

Dryer tri-ring retainer for drum support rollers.

OEM Part - Manufacturer #WPW10512946

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

OEM Part - Manufacturer #279769

The fuse can be tested using a multimeter meter