Refine Selection Here:
This part fits your Washer/Dryer Combo
Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is belt is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates
OEM Part - Manufacturer #341241
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel
OEM Part - Manufacturer #WP3392519
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
OEM Part - Manufacturer #WPW10314173
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Agitator Dogs - High-quality replacement part from Whirlpool. This kit can be used if the top part of the agitator is not moving properly but the bottom part is.
OEM Part - Manufacturer #80040
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.
OEM Part - Manufacturer #W10721967
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Mode shift actuator with 6 pin wire connection
OEM Part - Manufacturer #W10913953
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.
OEM Part - Manufacturer #WP3387134
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Door catch
OEM Part - Manufacturer #WPW10610880
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Suspension rod kit
OEM Part - Manufacturer #W10780045
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryness sensor bar
OEM Part - Manufacturer #WP3387223
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
White Touch Up Paint
OEM Part - Manufacturer #72017
Hazardous Material – Special Shipping Required
Order now and this item will ship out TODAY!
This part fits your Washer/Dryer Combo
Dryer idler pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin
OEM Part - Manufacturer #279640
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer tri-ring retainer for drum support rollers.
OEM Part - Manufacturer #WPW10512946
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.
OEM Part - Manufacturer #279769
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Washing machine agitator repair kit with a short length cam (there are other kits available for different models). This kit should be used when the top part of the agitator is not moving properly but the bottom part is.
OEM Part - Manufacturer #285809
Order by 8:00 PM ET, this part ships TODAY!