Refine Selection Here:
User Manual
This part fits your Washer/Dryer Combo
Whirlpool's transmission is a genuine replacement part for washing machines that ensures optimal turning motion for the drum, resulting in the best wash possible for clothes.
OEM Part - Manufacturer #3360629
Order now and this item will ship out TODAY!
This part fits your Washer/Dryer Combo
Washing machine water inlet valve kit with bracket. A long or slow fill cycle is often due to a restricted water valve. The valve should never be disassembled and cleaned, only replaced.
OEM Part - Manufacturer #285805
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.
OEM Part - Manufacturer #279769
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Agitator Bolt
OEM Part - Manufacturer #WP358237
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.
OEM Part - Manufacturer #WP697772
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer heating element wire connector kit. Wire with spade terminal & wire nut
OEM Part - Manufacturer #279457
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer drum felt seal kit. Includes silicone rubber adhesive.
OEM Part - Manufacturer #280114
Hazardous Material – Special Shipping Required
Order now and this item will ship out TODAY!
This part fits your Washer/Dryer Combo
Washing machine tub counterbalance spring. This spring offsets the weight of the motor on the front of the washer. If broke, the tub will lean forward and the tub will be off balance during the spin cycle.
OEM Part - Manufacturer #WPW10250667
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Washing machine main tub seal
OEM Part - Manufacturer #W10814296
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Screw
OEM Part - Manufacturer #WP308685
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Spring clip, knob
OEM Part - Manufacturer #WP688805
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Dryer door/washer lid switch kit. Comes with dryer mounting bracket, (2) wire terminals and (2) mounting screws.
OEM Part - Manufacturer #W10820036
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Shaft for dryer drum support roller. Rear shaft with right hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
OEM Part - Manufacturer #WPW10359272
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Adjustable leveling leg for washing machine. This leveling leg has a rubber foot. If the leveling leg is not adjusted properly, the washer will be off-balance and will vibrate or shake during operation.
OEM Part - Manufacturer #WPW10001130
Order by 8:00 PM ET, this part ships TODAY!
This part fits your Washer/Dryer Combo
Spring for idler pulley arm in dryer
OEM Part - Manufacturer #WPW10446781
Order by 8:00 PM ET, this part ships TODAY!
