Whirlpool CS5000XSW1 Dryer Replacement Parts

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Dryer drum drive motor with pulley

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.

Plastic leveling leg. White approximately 1" round x 1 3/4" long

Dryer door catch kit

Dryer tri-ring retainer for drum support rollers.

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

Dryer heating element wire connector kit. Wire with spade terminal & wire nut

Motor pulley, 60 hertz

Dryer drum felt seal kit. Includes silicone rubber adhesive.

White Touch Up Paint