Whirlpool Dryer WED49STBW1 Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

OEM Part - Manufacturer #WP3392519

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer electric heating element assembly

OEM Part - Manufacturer #279838

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #WPW10314173

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #349241T

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

OEM Part - Manufacturer #WP3406107

Whirlpool's replacement thermostat kit includes a thermal cut-off fuse, high-limit thermostat, and electrical connection hardware to ensure your clothes are perfectly dry. Keep up with laundry by installing this genuine Whirlpool replacement part.

OEM Part - Manufacturer #279816

Door handle, white. Snaps in place

OEM Part - Manufacturer #W10861225

Idler pulley for dryer drum drive belt

OEM Part - Manufacturer #WP691366

Consider replacing the Drive Belt while you have the dryer apart.

Dryer door catch kit

OEM Part - Manufacturer #279570

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

OEM Part - Manufacturer #WPW10717210

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Dryer drum drive motor with pulley

OEM Part - Manufacturer #279827

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

OEM Part - Manufacturer #WP3977767

The part may look different than the original but the part will still install and work the same.