Whirlpool Dryer Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

OEM Part - Manufacturer #WP3392519

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer electric heating element assembly

OEM Part - Manufacturer #279838

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

OEM Part - Manufacturer #349241T

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Whirlpool's replacement thermostat kit includes a thermal cut-off fuse, high-limit thermostat, and electrical connection hardware to ensure your clothes are perfectly dry. Keep up with laundry by installing this genuine Whirlpool replacement part.

OEM Part - Manufacturer #279816

Idler pulley for dryer drum drive belt

OEM Part - Manufacturer #WP691366

Consider replacing the Drive Belt while you have the dryer apart.

Drive Clutch Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the drive belt and the splutch works with the mode shift actuator to operate the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems.

OEM Part - Manufacturer #W10721967

The drive belt wears out over time. You may want to replace the drive belt while the washer is apart.

Dryer cycling thermostat with internal bias heater, L155-25. If the dryer won't heat, it is unlikely that this thermostat is causing the issue, as the thermal fuse or thermal cut-out normally fail first.

OEM Part - Manufacturer #WP3387134

Dryer drum drive motor with pulley

OEM Part - Manufacturer #279827

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

OEM Part - Manufacturer #WP3977767

The part may look different than the original but the part will still install and work the same.

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

OEM Part - Manufacturer #WP694089

Motor pulley, 60 hertz

OEM Part - Manufacturer #WP8066184

Door Catch

OEM Part - Manufacturer #WP3389441

Door seal

OEM Part - Manufacturer #W10906683