Whirlpool LEN2000KQ2 Dryer Replacement Parts

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

A bad fuse will have no continuity meaning the electrical path is broken. A multimeter can be used to test it for continuity.

Dryer electric heating element assembly

The heating element and many other parts can be tested using a volt/ohm meter which is a handy item to have in any do it yourselfers tool box.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

The drum support roller kit, 349241T. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

The drum rollers and drum roller axles often wear out at the same time. If the drum roller axles are worn out, replace them along with the drum rollers.

Dryer high-limit thermostat, L250-80, with terminal extension arm. This thermostat should be closed for continuity at room temperature and opens at around 250 degrees Fahrenheit. If the dryer won't heat, the high-limit thermostat might be defective.

The part may look different than the original but the part will still install and work the same.

Idler pulley for dryer drum drive belt

Consider replacing the Drive Belt while you have the dryer apart.

Dryer drum drive motor with pulley

Dryer blower wheel. Used on 29 inch Whirlpool built models with lint filter on top. To remove the blower wheel, unscrew the blower wheel clockwise off the motor shaft.

Dryer door catch kit

Dryer drum rear felt seal kit with adhesive.

Dryer tri-ring retainer for drum support rollers.

This is a genuine replacement part. Whirlpool 349639 Lint Screen.

Use this brush to clean the dryers venting.