Whirlpool 3RLEQ8033SW1 Dryer Replacement Parts

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer idler pulley assembly. Includes bracket and pulley wheel

Consider replacing the belt while the dryer is apart.

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

The dryer belt wears out over time. Consider replacing the belt while the dryer is apart.

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Dryer door catch kit

Dryer tri-ring retainer for drum support rollers.

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Heating element thermal cut-off (thermal fuse) 360 degrees and high-limit thermostat 250 degrees. The thermal fuse is a safety device designed to protect the dryer from overheating. A multimeter can be used to test the fuse. Always check the dryer venting when replacing a blown thermal fuse.

The fuse can be tested using a multimeter meter

White Touch Up Paint

Outer grille

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.